TM 5-4210-233-14&P-2
6-10. CYLINDER BLOCK REAR END PLATE
This task covers:
a. Removal
c. Follow-on maintenance
b. Installation
TOOLS REQUIRED
MATERIALS/PARTS
Too[ Kit, General Mechanics, Automotive
Grease, automotive and artillery
(Appendix B, Section III, Item 1)
(Item 1, Appendix E)
Adhesive Sealant (Item 35, Appendix E)
Shop Equipment, Automotive
Gasket (Figure 101, Appendix F)
Maintenance and Repair
(Appendix B, Section III, Item 4)
EQUIPMENT CONDITION
Engine Mounted on Engine Stand
Camshafts Removed (see para 6-36.)
Idler Gear Removed (see para 6-35.)
a. Removal.
NOTE
Note direction of special washer during removal to aid in correct installation.
(1)
Remove screw (1), special washer (2), and dummy hub (3) from end plate (4).
(2)
Remove screw (5) and lockwasher (6) from end plate (4).
(3)
Remove four screws (7) and lockwashers (8) from end plate (4).
6-69