TM 5-4210-233-14&P-2
6-10. CYLINDER BLOCK REAR END PLATE - Continued
(4)
Remove end plate (4).
(5)
Remove gasket (9) from end
plate (4) and engine block (10).
CAUTION
Support rear end plate on flat, even
surface when removing screw inserts to
prevent warping or bending plate.
(6)
Remove two screw inserts (I 1)
from end plate (4).
(7)
Remove eight screw
inserts (12) from end plate (4).
b. Installation.
CAUTION
Support rear end plate on flat, even
surface when installing screw inserts to
prevent warping or bending end plate.
(1)
Press eight screw inserts
(1) into back of end plate.
(2)
Press two screw inserts (3)
into front of end plate (2).
(3)
Coat gasket (4) with
grease (Item 1, Appendix E)
and install over dowel pins (5)
onto engine block (6).
6-70