TM 5-4210-233-14&P-2
6-60. THIRD CLUTCH AND CENTER SUPPORT HOUSING - Continued
(6)
Measure diameter of main shaft bearing
surfaces (8) inside transmission housing (9).
(7)
Measure inside diameter of bushing (IO).
(8)
If bushing (10) to main shaft bearing surface (8)
clearance is greater than 0.0065 in. (0.17 mm),
remove bushing.
c. Cleaning and Inspection.
WARNING
Dry cleaning solvent P-D-680 is potentially dangerous. Avoid
repeated and prolonged breathing of vapors and skin contact with the liquid. Do not use near open flame,
arcing equipment or other ignition sources. Always wear eye protection and protective clothing. The flash point
of P-D-680 is 100 to 138 deg. F (38 to 59 deg. C).
(1)
Clean all metallic parts with dry cleaning solvent (Item 3, Appendix E) and inspect for damage.
Replace damaged parts.
(2)
Replace piston release springs if any three of each
set of 20 do not meet the following load-height
requirements:
(a) Length without load must be at ieast 1.29 in. (32.7
mm).
(b) Length under load must be at least 0.82 in. (20.8
mm) with load of 4.3 to 5.7 lb (2 to 2.6 kg).
(3)
Measure thrust washer thickness. Thickness must be
no less than 0.091 in. (2.31 mm).
d. Assembly.
(1)
Place center support housing (1) on press, hub side
up.
(2)
Install prebored bushing (2). Make sure oil hole in
prebored bushing is aligned with oil hole in center
support housing (1).
6-351
