TM 5-4210-233-14&P-2
6-60. THIRD CLUTCH AND CENTER SUPPORT HOUSING - Continued
(5)
Install compressor sleeve on hub of center support housing (2) and place compressor bar across
transmission housing (4) with two screws (9).
(6)
Tighten compressor center screw to 5 Ib-ft (7 Nm) to compress center support housing (2).
(7)
Place snap ring in retaining ring opening (1 0). Measure retaining ring opening with each of four
colored lugs on gauge to determine iug with tightest fit.
(a)
Blue color coded retaining ring is 0.148 to 0.1 50-in. (3.76 to 3.81 mm) thick.
(b)
Yellow color coded retaining ring is 0.152 to 0.154-in. (3.86 to 3.91 mm) thick.
(c)
White color coded retaining ring is 0.155 to 0.157-in. (3.94 to 3.99 mm) thick.
(d)
Red color coded retaining ring is 0.158 to 0.160-in. (4.01 to 4.06 mm) thick.
(8)
Install retaining ring (11) that has same color code as lug of gauge. Retaining ring gap must be
opposite oil pan side (12) of transmission housing (4).
(9)
Remove compressor bar and compressor sleeve.
6-355