TM 5-4210-233-14&P-2
6-21. ROCKER ARMS
e.
Installation.
(1) Thread each of three rocker arms (2) onto push rod
(11) until end of push rod is above inside of clevis
yoke (12).
(2) Coat shaft (4) with oil (Item 10, Appendix E) and slide
it through three rocker arms (1).
(3) Install two brackets (5), one over each end of shaft
(4), with finished face next to rocker arms (1).
(4) Position rocker arms (1) down on valve bridge (6).
(5) Hold each push rod (2) while tightening three locknuts
(7).
(6) Remove caps from four fuel line connectors (8).
(7) Install two fuel tubes (9 and 10).
(8) Tighten four nuts (11) to 120 lb-in (13.6 N m) using
fuel line nut wrench (Item 37, Appendix B, Section
111).
f.
Follow-on Maintenance.
(1) Install engine brake retarder (see para 6-34).
(2) Install engine brake wire harness.
(3) Install rocker cover (see para 4-140).
6-116