TM 5-4210-233-14&P-2
6-13. CYLINDER HEAD REMOVAL/INSTALLATION - Continued
c.
Installation.
CAUTION
Never
install
used
compression gaskets. They
will cause compression leaks.
(1)
Install four compression
gaskets (1), sixteen
water seals (2), oil seal
(3), and seal strip
gasket (4).
(2)
Remove paper covering
from back of two support
shims (5) and install
glued side down.
(3)
Install two cylinder head
guide studs into two
bottom corners of
cylinder block (6).
(4)
Align cylinder head (7)
with guide studs while
operating suitable lifting
device.
(5)
Lower cylinder head (7)
on cylinder block (6).
(6)
Remove three nuts (8),
washers (9), and lifting
fixture from studs (10).
(7)
Install eight cylinder
head screws (11) and
washers (12). Remove
two guide studs and
install two remaining
cylinder head screws
and washers. Tighten
screws to 15 to 20 lb-ft
(20 to 27 N.m).
6-83