DRAFT
TM 5-4210-249-13&P-1
0105
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
TFFT02796
WARNING
ICON 3
Remove rings, wristwatches, neck chains, and any other jewelry before working
around vehicle. Jewelry can catch on equipment and cause serious injury. Jewelry
and tools may short across electrical circuits and cause damage to equipment, or
severe burns or electrical shock to personnel.
Step 26.
Turn battery disconnect switch to OFF position (WP 0007). Disconnect valve control
wire harness direct tank fill valve connector. Put pump operator's panel DIRECT TANK
FILL switch to OPEN position (WP 0004). Turn battery disconnect switch to ON
position (WP 0007). With a test lead set, check for 22 to 28 VDC between valve control
wire harness wire 2315 (yellow) at valve control wire harness direct tank fill wire
harness connector, terminal 1 and a known good ground.
If 22 to 28 VDC are not present, go to Step 31.
Step 27.
Put DIRECT TANK FILL switch to OFF position (WP 0004). Turn battery disconnect
switch to OFF position (WP 0007). With a test lead set, check for continuity across wire
2200 (black) from valve control wire harness direct tank fill valve connector, terminal 2
to a known good ground.
If there is no continuity, repair wire 2200 in valve control wire harness if
repairable (TM 9-2320-325-14&P), or replace valve control wire
harness (WP 0463).
0105-23
