DRAFT
TM 5-4210-249-13&P-1
OPERATOR MAINTENANCE
PUMP AND ROLL PROCEDURES
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
TFFT00326P
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
WARNING
ICON 66, 42
Open and close all valves slowly during any procedure. Sudden changes in
pressure may cause equipment to react faster than personnel can be alerted.
Ensure surrounding personnel are aware of changes being made to settings on
equipment. Failure to comply may result in injury or death to personnel and
damage to equipment.
Pump and roll procedures must be performed from vehicle cab. Do not use pump
operator's panel for pump and roll procedures. Failure to comply may result in
injury or death to personnel.
Due to poor driver visibility to curb side of vehicle over doghouse and cab mounted
equipment, a crew member must be seated in passenger seat when vehicle is in
motion. Failure to comply may result in damage to equipment or injury or death to
personnel.
NOTE
For maximum bumper turret and roof turret performance, maintain 200 to 210 psi (1,379 to
1,448 kPa) on pump discharge gauge.
1.
Make sure crew cab roof hatch is closed and secured (WP 0018).
2.
Put TANK TO PUMP switch (1) to ON position. Indicator light (2) will illuminate.
3.
Start water pump engine (WP 0022).
4.
Prime water pump (WP 0023) until pressure registers on pump discharge gauge.
5.
For foam operations, refer to (WP 0034).
6.
Set pressure governor (WP 0024).
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
0028-1