TM 5-4210-233-14&P-2
6-31. FLYWHEEL HOUSING AND REAR OIL SEAL
This task covers:
a. Removal
c. Follow-on Maintenance
b. Installation
TOOLS REQUIRED
MATERIALS/PARTS REQUIRED
Tool Kit, General Mechanics, Automotive
Oil, lubricating, Item 10, Appendix E
(Appendix B, Section III, Item 1)
Grease, automotive and artillery
(Item 1, Appendix E)
Shop Equipment, Automotive
Compound, sealing pipe thread
Maintenance and Repair
(Item 2, Appendix E)
(Appendix B, Section III, Item 4)
Compound, sealing, lubricating
(Item 31, Appendix E)
Stud set alignment (Appendix B, Section III, Item 41)
Tags, identification (Item 32, Appendix E)
Installer, seal (Appendix B, Section III, Item 42)
Cloth, crocus, abrasive (Item 34, Appendix E)
Lifting eyes (Appendix B, Section III, Item 43)
Gaskets (Figure 112, Appendix F)
Oil Seal (Figure 112, Appendix F)
PERSONNEL REQUIRED
2
EQUIPMENT CONDITION
Air Compressor Removed (see para 5-17.)
Starting Motor Removed (see para 5-12.)
Power Steering Pump Removed
(see para 5-26.)
Engine Removed (see para 5-11.)
Oil Pan Removed (see para 5-27.)
Flexplate Removed (see para 6-30.)
Alternator Drive Removed (see para 6-42.)
a. Removal.
(1) Install two lifting eyes (Appendix B, Section III, Item 43).
(2) Support flywheel housing (1) with suitable lifting device.
(3) Remove three screws (2), lockwashers (3), washers (4), and left bank bracket (5).
(4) Remove three screws (6), lockwashers (7), washers (8), and right bank bracket (9).
6-163