TM 5-4210-233-14&P-2
6-31. FLYWHEEL HOUSING AND REAR OIL SEAL- Continued
(23) Install four aligning studs (49) from
alignment stud set (Appendix B, Section III,
Item 41) in engine block.
WARNING
Make sure lifting device is secured. Keep hands
and feet out from under flywheel housing when
removing from engine. Falling parts may cause
serious personal in- jury.
(24) Remove flywheel housing (1) from rear
end of engine block.
ALIGNING STUDS
(25) Remove pipe plug (50) from bottom of
flywheel housing (1).
(26) Remove pipe plug (51) from back side of
flywheel housing (1).
(27) Remove and discard crankshaft rear oil
seal (52).
6-168