DRAFT
TM 5-4210-249-13&P-1
0103
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
TFFT02734
WARNING
ICON 3
Remove rings, wristwatches, neck chains, and any other jewelry before working
around vehicle. Jewelry can catch on equipment and cause serious injury. Jewelry
and tools may short across electrical circuits and cause damage to equipment, or
severe burns or electrical shock to personnel.
NOTE
Step 6 will isolate fault that may exist in cab FOAM B LEVEL gauge and wire harness
leading to gauge, or will show if fault exists in pump operator's panel FOAM B LEVEL
gauge.
Step 6.
Turn battery disconnect switch to OFF position (WP 0007). Open pump operator's
panel housing (WP 0325). Disconnect cab water level gauge wire harness connector
from pump operator's panel WATER LEVEL gauge. Disconnect cab foam level gauge
wire harness connector from pump operator's panel FOAM B LEVEL gauge. Connect
cab water level gauge wire harness connector to pump operator's panel FOAM B
LEVEL gauge. Turn battery disconnect switch to ON position (WP 0007). Check if cab
WATER LEVEL gauge illuminates (WP 0004).
If cab WATER LEVEL gauge does not illuminate, replace pump operator's
panel FOAM B LEVEL gauge (WP 0322).
0103-4
