TM 5-4210-233-14&P-2
6-58. REAR COVER AND FIRST CLUTCH ASSEMBLY - Continued
(14)
Install 30 piston release springs (13) in first clutch piston (3).
(15)
Install piston spring retainer (14) on piston release springs (13).
(16)
Using clutch spring compressor (Appendix B, Section III, Item
73), push down on piston spring retainer (14) and piston release
springs (13) until retaining ring groove in rear cover (8) is
cleared.
(17)
Install retaining ring (15). Remove clutch spring compressor.
(18)
Install small orifice plug (16) in output shaft (17).
(19)
Coat output shaft bushing (18) with retaining compound (Item
6, Appendix E).
(20)
Install output shaft bushing (18) in output shaft (17) using
output shaft bushing installer (Appendix B, Section III, Item 78).
(21)
Install speedometer drive gear (19), spacer (20), and bearing
(21) on output shaft (17).
(22)
Install output shaft (1 7) in rear cover (8).
6-338
