TM 5-4210-233-14&P-2
6-36. CAMSHAFTS AND PULSE WHEEL - Continued
(6)
Turn gear (5) to reach all rear end bearing
screw holes.
(7)
Install six screws (8) and lockwashers (9)
to both camshaft rear end bearings (10)
and engine block (2).
(8)
Tighten screws (8) to 35 to 40 lb-ft (47 to
54 Nm).
(9)
Align holes in three intermediate bearings
(11) on right and left camshafts (1 and 3)
with tapped holes in engine block (2).
(10)
Install three lock screws (12).
(11)
Tighten lock screws (12) to 15 to 20 lb-ft
(20 to 27 Nm).
(12)
Apply clean engine oil (Item 10, Appendix E)
to left bank camshaft front end bearing
journal (13).
(13)
Install new gasket (14) and bearing (15) on
camshaft (3).
(14)
Install three screws (16) and lockwashers (1
7) to bearing (15) and engine block (2).
(15)
Tighten screws (16) to 35 to 40 lb-ft (47 to 54 Nm).
NOTE
Spacers have polished outside diameters.
(16)
Install new oil seal (18) and spacer (19).
6-219