TM 5-4210-233-14&P-2
6-36. CAMSHAFTS AND PULSE WHEEL - Continued
NOTE
Both ends of lockring must cover split line of bearing.
(7)
Measure and note diameters of three bearing journals (3). Replace camshaft (1) if any diameter is
less than 1.4980 in. (38.049 mm).
(8)
Measure and note diameters of two end bearing journals (4). Replace camshaft (1) if any diameter
is less than 1.4960 in. (37.998 mm).
(9)
Measure and note inside diameter of four end bearings bushings (5).
(10)
Put lower half (6) of three intermediate bearings (7) together with top half (8).
(11)
Install six lockrings (9) over three intermediate bearings (7).
(12)
Measure and note inside diameter of three intermediate bearings (7).
(13)
Take measurement recorded in step (7) and subtract from measurement recorded in step (12).
Total difference may not exceed 0.009 in. (0.23 mm).
(14)
Replace three intermediate bearings (7) if clearance exceeds limit.
(15)
Measure thickness of four rear end bearing thrust washers (10) and replace if less than 0.119 in.
(3.02 mm).
(16)
Take measurement recorded in step (8) and subtract it from measurement recorded in step (9).
Total difference may not exceed 0.006 in. (0.15 mm).
6-215
