TM 5-4210-233-14&P-2
6-15. INJECTOR TUBES - Continued
(2) Install pilot into injector tube installer through bottom of cylinder head (2).
(3) Tap pilot to loosen injector tube (1).
(4) Remove injector tube (1), preformed packing (3), pilot, and installer from cylinder head (2).
b. Installation.
NOTE
Injector tube must be reamed before injectors can
be installed.
All injector tubes are installed the same way.
(1) Clean dirt from injector tube (1) and hole.
(2) Install preformed packing (2) into cylinder head counterbore (3).
(3) Tap injector tube (1) into injector tube hole using installer until bottom of rim of installer is flush with
cylinder head (4).
6-98