Section V. MAINTENANCE OF CAB ASSEMBLY, LIGHTS, SWITCHES, GAUGES, CONTROLS, AND INDICATORS

TM5-4210-224-14&P

Section V.

MAINTENANCE OF CAB ASSEMBLY, LIGHTS, SWITCHES, GAUGES, CONTROLS,

AND INDICATORS

Para.

Cab Assembly, Lights, Switches,

Cab Panels Repair................... -14

Gauges, Controls and

General ..................................5-12

Indicators Replacement..................... -13

5-12.

GENERAL.

This section contains information on the maintenance of the cab assembly, lights, switches, gauges, controls, and

indicators that are maintainable at the Direct Support level.

5-13.

CAB ASSEMBLY, LIGHTS, SWITCHES, GAUGES, CONTROLS, AND

INDICATORS REPLACEMENT.

This task covers:

a. Removal

b. Installation

INITIAL SETUP

General Safety Instructions

Tools

General Mechanics Tool Kit

Engine OFF

Hoist and Sling

Transmission in (N) neutral.

Parking brake and micro-brakelock set.

Batteries disconnected.

REMOVAL

g. Remove bolts which hold the master cylinder to

cab.

a. Remove grille (paragraph 4-155).

h. Unclip the brake and clutch lines from cab

b. Remove batteries (paragraph 4-106).

(paragraph 4-209).

c. Drain radiator (paragraph 4-72).

i. Lower t e master cylinder and place on lower

chassis.

d. Disconnect heater hoses at cab connections

(paragraph 4-77).

j. Disconnect speedometer cable (paragraph 4-

127).

e. Disconnect accelerator linkage (paragraph 4-

k. Disconnect all electrical lines that run between

89).

cab and chassis including the cab-chassis

f. Disconnect the steering coupling and mark for

ground strap, headlight wires, horn wires, and

alignment later (paragraph 4-221).

brake light switch (paragraphs 4-182 and 4-183).

5-28