INSTALLATION - TM-5-4210-224-14-P0486

TM5-4210-224-14&P

5-13.

CAB ASSEMBLY, LIGHTS, SWITCHES, GAUGES, CONTROLS, AND

INDICATORS REPLACEMENT. (Continued)

f. Install transmission gear selector (paragraph 4-

l. Disconnect and remove transmission gear

193).

selector (paragraph 4-193) and transfer case

shift lever (paragraph 4-201).

g. Connect all electrical lines that run between the

cab and chassis, including the cabchassis

m. Remove the rear mounting hardware which hold

ground strap, headlight wires, horn wires, and

the cab to the chassis.

brake light switch (paragraphs 4-182 and 4-183).

n. Remove the front mounting hardware holding

h. Connect speedometer cable (paragraph 4-127).

the cab to the chassis.

i. Install master cylinder (paragraph 4-196).

WARNING

j. Clip brake and clutch lines to cab (paragraph 4-

When lifting an object make sure the

209).

hoist and sling are fastened securely.

Be sure the item being lifted does not

k. Connect steering coupling (paragraph 4-221).

exceed the capacity of the lifting

device.

l. Connect accelerator linkage (paragraph 4-89).

o. Engage hoist and sling to cab. Remove cab by

m. Connect heater hoses at cab connections

raising slightly to clear support brackets.

(paragraph 4-77).

p. Remove lifting sling and hoist.

n. Service radiator (paragraph 472).

INSTALLATION

o. Install and connect batteries (p agraph 4-106).

WARNING

p. Install grille (paragraph 4-155).

When lifting an object make sure the

hoist and sling are fastened securely.

Be sure the item being lifted does not

exceed the capacity of the lifting

device.

a. Install lifting sling and hoist.

b. Raise cab over chassis and lower into position.

c. Install front mounting hardware.

d. Install rear mounting hardware.

e. Install transfer case shift lever (paragraph 4-

201).

5-29