BRAKE SYSTEM PIPES AND HOSES REPLACEMENT.

TM5-4210-224-14&P

4-209. BRAKE SYSTEM PIPES AND HOSES REPLACEMENT.

This task covers:

a. Removal

b. Installation

INITIAL SETUP

Tools

Equipment Condition

Flaring Tool

Para. Condition Description

(J-23530)

4-203 Wheel Assembly Removed

Tube Cutter

(J-23533-B)

General Safety Instructions

General Mechanics Tool Kit

Engine OFF.

Transmission in (N) neutral.

Parking brake and micro-brakelock set.

Materials/Parts

Brake Fluid

(Appendix D, Item 4)

Pipes and Hoses As Required

(Appendix E, Page E-210)

REMOVAL

NOTE

The

hydraulic

brake

system

components are interconnected by

special steel piping and flexible

hoses: When the hydraulic pipes or

hoses have been disconnected for

any reason, the brake system must

be bled after reconnection.

Clean dirt, grease and other

foreign material off fittings at all

ends.

a. On the front brakes, disconnect the bolt (4) and

copper washers (3) at the brake caliper.

b. Disconnect the nut or clip (1) attaching the hose

(2) to the frame and remove the hose.

to the drum and remove the hose and pipe.

c. At the rear, disconnect the nut or clip (1)

attaching the hose (2) to the frame.

e. If pipe replacement is necessary, remove the

pipe from the hose (2).

d. Disconnect the bolt (4) and washers (3)

attaching the hose (2) and pipe

INSTALLATION

CAUTION

When installing hose, contact after

assembly must not be made with

any suspension components.

4-288