Test Set Subassembly Disassembly and Assembly

TM 9-4931-363-14&P

4-15. Test Set Subassembly Disassembly and Assembly

NOTE

(fig. B-5).

If B1, R18, or R19 require replacement because

Remove items (1) through (5) in disassembly sequence

of a defect in one or more of these

and assemble in reverse disassembly sequence.

components, all three components must be

replaced. Resistors R18 and R19 are furnished

with the resolver as RT-2 and RT-1,

4-16. Test Set Container Disassembly and Assembly (fig.

respectively. These resistors are matched and

B-6).

i d e n t i f i e d with the resolver and must be

installed concurrently with replacement of the

a. Remove items (1) through (6) in disassembly

resolver.

sequence and assemble in reverse disassembly sequence.

4-19. Rear Bracket Assembly Disassembly and Assembly

b. Remove hinges by drilling heads of rivets from

(fig. B-9).

outside of box, using a 5/32-inch drill. Drill 1/16 to 1/8

inch deep and remove the head of the rivet with a chisel.

Remove items (1) through (37) in disassembly sequence.

P u n c h out the remaining portion of the rivet with a

Unsolder and mark leads where necessary. Assemble in

1 / 8 - i n c h punch. Install new hinges using new rivets

reverse disassembly sequence.

furnished with the hinges.

4-20. Top Panel Assembly Disassembly and Assembly (fig.

B-10).

4-17. Test Set Chassis Assembly Disassembly and Assembly

(fig. B-7).

Remove items (1) through (31) in disassembly sequence.

Unsolder and mark leads where necessary. Assemble in

The multimeter is fragile. Do not drop it during

reverse disassembly sequence.

disassembly and assembly of the top panel.

4-18. Front Bracket Assembly Disassembly and Assembly

Remove items (1) through (48) in disassembly sequence.

(fig. B-8).

Unsolder and mark leads where necessary. Assemble in

reverse disassembly sequence.

a. Remove items (1) through (36) in disassembly

sequence. U n s o l d e r and mark leads where necessary.

4-21. Organizational HSS Boresight Kit Disassembly and

Assemble in reverse disassembly sequence.

Assembly (fig. B-11).

b. Removal of resolver B1 (item 32) requires

Remove items (1) through (3) from item (4). To

readjustment of B1 in accordance with paragraph 4-24.

reassemble, install items (1) through (3) in item (4).

4-34