DRAFT
TM 5-4210-249-13&P-2
0164
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
WARNING
ICON 3
110-volt AC power is potentially lethal. Do not work on AC wiring when it is
connected to a power source. Failure to comply may cause injury or death to
personnel.
Remove rings, wristwatches, neck chains, and any other jewelry before working
around vehicle. Jewelry can catch on equipment and cause serious injury. Jewelry
and tools may short across electrical circuits and cause damage to equipment, or
severe burns or electrical shock to personnel.
NOTE
Perform the following Steps on non-operating receptacle circuit as indicated in table
below.
All receptacle circuits are troubleshot the same way. Driver side pump house receptacle
circuit shown.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Table 1.
Receptacle to Circuit Breaker List
Driver Side Pump House Receptacle
Circuit Breaker 7
Passenger Side Pump House Receptacle
Circuit Breaker 8
Driver Side Rear Receptacle
Circuit Breaker 9
Passenger Side Rear Receptacle
Circuit Breaker 10
Reciprocating Saw Receptacle
Circuit Breaker 11
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Step 2.
Turn off hydraulic generator (WP 0021). Shut vehicle engine OFF (TM 9-2320-347-10).
Install jumperwire between black wire at appropriate circuit breaker and ground. Then
check for continuity from black wire on non-operating receptacle terminal to ground.
If there is no continuity, repair black wire between receptacle and circuit
breaker if repairable (TM 9-2320-325-14&P), or replace power cord
between circuit breaker and receptacle (WP 0361).
