DRAFT
TM 5-4210-249-13&P-1
0106
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
TFFT03421
WARNING
CON 3
Remove rings, wristwatches, neck chains, and any other jewelry before working
around vehicle. Jewelry can catch on equipment and cause serious injury. Jewelry
and tools may short across electrical circuits and cause damage to equipment, or
severe burns or electrical shock to personnel.
Step 4.
Turn battery disconnect switch to OFF position (WP 0007). Open pump operator's
panel (WP 0325). Disconnect valve control wire harness connector from DRIVER
MAIN INLET valve control. Disconnect valve control wire harness connector from
TANK FILL & RE-CIRCULATING LINE valve control. Connect driver main inlet valve
control wire harness connector to TANK FILL & RE-CIRCULATING valve control. Turn
battery disconnect switch to ON position (WP 0007). While an assistant monitors
operation of driver main inlet valve, push pump operator's panel TANK FILL &
RE-CIRCULATING valve control OPEN and CLOSE buttons (WP 0004). Check if
TANK FILL & RE-CIRCULATING valve control OPENED (green) and CLOSED (red)
indicators illuminate before driver main inlet valve is fully opened or closed.
If TANK FILL & RE-CIRCULATING valve control indicators do not illuminate
before driver main inlet valve is fully opened or closed, reconnect valve
control wire harnesses to original positions and replace DRIVER MAIN
INLET valve control (WP 0418).
0106-4
