TM 5-4210-233-14&P-2
6-32. PISTON, CONNECTING ROD AND LINER - Continued
(7) Coat inside of cylinder liner (6) with lubricating oil (Item 10, Appendix E).
(8) Hold cylinder liner (6), flange end down, on wood block and another person places ring compressor with
piston and connecting rod assembly (7) on cylinder liner.
(9) Align numbers on rod bearing cap (8) with marks on cylinder liner (6).
(10) Push piston and connecting rod assembly (7) into cylinder liner (6) until piston is free from ring
compressor. Remove ring compressor.
(11) Remove two nuts (9), bearing cap (8), and bearing shells (10).
(12) Push piston into cylinder liner (6) until compression rings pass cylinder liner ports (11).
(13) Coat connecting rod bearing shells (10) with lubricating oil (Item 10, Appendix E).
(14) Position crankshaft connecting rod journal (12) of cylinder being worked to bottom of its travel.
(15)
Coat journal (12) with lubricating oil (Item 1O, Appendix E).
(1 6) Align mark on cylinder liner (6) with mark on engine block (2).
(17) Slide cylinder liner (6) with piston and connecting rod assembly (7) into engine block (2) while
another person guides connecting rod assembly over crankshaft journal.
6-181