| |
TM 9-254
Section IV. TAGGING WIRES AND LOOSE PARTS DURING DISASSEMBLY
6-12.
General.
When performing maintenance tasks, it often becomes necessary to loosen and disconnect wires or parts of certain items
to gain access to other areas where the maintenance task is to be performed. Before removal of such wires or parts it is
recommended that they be tagged to help remember their proper location after they have been disassembled.
6-13.
Tagging.
a.
General. Make a tag by cutting a piece of masking tape of convenient size for the wire or part being
identified. On this tag write the part number, connector and pin number, terminal strip and terminal number, or some other
method of identifying the item being removed.
b.
Item Tagging (fig. 6-25). A recommended procedure for tagging wires is as
follows:
(1)
Remove wire (1) from its terminated location on the terminal board.
NOTE
Tag should stick to wire so the marking can easily be read.
(2)
Mark the wire by wrapping tag (2) around wire (1) before removing next wire.
Figure 6-25. Item Identification Tags
6-21
|