| |
TM 9-254
6-11.
Safety Wiring Procedures - Continued
NOTE
Steps (5) through (9) refer to figure 6-24.
(5)
At each screwhead, bring wire end on left (1) over top of right-hand wire. Using wiretwisting pliers (2),
twist wire until it just reaches the next screwhead.
(6)
If wiretwisting pliers are not available, safety wire may be twisted by hand (3).
(7)
Push top wire (4) through hole in screwhead. Bend bottom wire (5) around left side of screwhead to
meet wire (4) coming out of hole in screwhead.
(8)
Bring wire end (5) over top of right-hand wire (4) and twist wire about four or five turns (6) beyond the
last screwhead.
(9)
Using diagonal cutting pliers (7), cut off end of wires leaving about four or five turns beyond last
screwhead.
Figure 6-24. Safety Wiring Installation - Multiconnection
6-20
|