|
| |
TM 9-254
6-11.
Safety Wiring Procedures - Continued
NOTE
Steps (1) through (4), refer to figure 6-23.
(1)
Screws, nuts, and bolts made for lockwiring have one or more holes (1) for the insertion of safety wire.
(2)
To install safety wire, plan a path (2) and determine the length of wire needed to do the job.
(3)
Insert safety wire (3) through the hole (4) of the first screw, to about the middle of the length of wire
being used.
(4)
Bend wire end around the right side of screwhead (5).
Figure 6-23. Safety Wire Installation
6-19
|
