DRAFT
TM 5-4210-249-13&P-3
0506
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
TFFT02261
3.
Lower window (4) to stop (5).
4.
Remove four remaining screws (1), lockwashers (2), and regulator (3) from door (5). Discard lockwashers.
5.
Prop window (4) with wooden block.
6.
Remove two locknuts (7) from channel (8) on door (6).
7.
Push window (4) completely up and remove channel (8) from door (6).
8.
Remove seal (9) from channel (8)
9.
Remove two screws (10) from channel (8).
10. Lower window (4) to bottom of door (6).
11. Remove window (4) and channel (11) from door (6).
12. Remove channel (11) and rubber seal (12) from window (4).
END OF TASK
INSTALLATION
NOTE
Flat side of regulator mounting bracket must face inside of vehicle. Angled corner of glass
must be at bottom. Channel must be mounted to glass 1.5 in. (3.8 cm) from edge of glass
at angled corner.
1.
Install channel (11) and rubber seal (12) on window (4).
2.
Install window (4) in bottom of door (6) and channel (11).
0506-2