DRAFT
TM 5-4210-249-13&P-3
0473
INSTALLATION/ADJUSTMENT
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
TFFT00904
NOTE
Install belts as noted prior to removal.
1.
Install fuel pump drive belt (6) on three pulleys (7), (8), and (5).
2.
Push fuel pump (4) away from coolant pump pulley (5) and tighten fuel pump drive belt (6) to 101 lb-ft
(450 Nm) as indicated by V-belt tension gauge.
3.
Hold fuel pump (4) in position and tighten two screws (1) and (2).
NOTE
Use the suggested tension setting for initial tensioning. When belt is installed, run water
pump engine under load for 15 minutes, shut down and readjust belt tension.
Suggested belt tensions have a range of +/- 11 lb-ft (15 Nm).
4.
Start pump engine and run under load for 15 minutes.
5.
Shut down engine and readjust fuel pump drive belt (6) tension to 67 lb-ft (300 Nm), as indicated by V-belt
tension gauge.
END OF TASK
FOLLOW-ON MAINTENANCE
1.
Install pump house panels J and S (WP 0540)
2.
Install water pump engine alternator belt (WP 0224)
3.
Install water pump engine heat exchanger (WP 0240)
END OF TASK
END OF WORK PACKAGE
0473-2