DRAFT
TM 5-4210-249-13&P-2
0155
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
WARNING
ICON 3
Remove rings, wristwatches, neck chains, and any other jewelry before working
around vehicle. Jewelry can catch on equipment and cause serious injury. Jewelry
and tools may short across electrical circuits and cause damage to equipment, or
severe burns or electrical shock to personnel.
Step 14.
Put EMERG MASTER and SIDE WARNING switches to off position (WP 0004). Turn
Service Drive Lights Off (TM 9-2320-347-10). Remove non-operating lower side
warning light (WP 0351). Turn Service Drive Lights On (TM 9-2320-347-10). Put
EMERG MASTER and SIDE WARNING switches to on position (WP 0004). With a test
lead set, check for 22 to 28 VDC between main wire harness wire 1651 (brown) from
main wire harness side warning light connector, terminal 3 to a known good ground.
If 22 to 28 VDC are not present, repair wire 1651 in main wire harness if
repairable (TM 9-2320-325-14&P), or replace main wire harness
(WP 0455).
Step 15.
Put EMERG MASTER and SIDE WARNING switches to off position (WP 0004). Turn
Service Drive Lights Off (TM 9-2320-347-10). Turn battery disconnect switch to OFF
position (WP 0007). With a test lead set, check for continuity across main wire harness
wire 1640 (black) from main wire harness side warning light connector, terminal 1 to a
known good ground.
a.
If there is continuity, replace lower side warning light (WP 0351).
b.
If there is no continuity, repair wire 1640 in main wire harness if
repairable (TM 9-2320-325-14&P), or replace main wire harness
(WP 0455).
0155-9