|
| |
TM 5-4210-233-14&P-1
5-22.
BLOWER REPAIR - Continued
(16)
Turn seal rings (3) so gaps face top of blower housing (7).
(17)
Tilt rear end plate (10) back so that back side of seal rings (3) insert into seal ring collars first.
(18)
Position rear end plate (10) and align dowel pins (11) to holes in blower housing (7).
(19)
Tap rear end plate (10) onto blower housing (7).
(20)
Install and tighten two screws (12) to 10 Ib-ft
(14 N•m).
(21)
Apply lubricating oil (Item 10, Appendix E) to two
ball bearings (13).
(22)
Install two ball bearings (13), numbered end up,
in rear end plate (10) with bearing installer.
5-133
|
