|
| |
TM 5-4210-233-14&P-1
5-22.
BLOWER REPAIR - Continued
NOTE
Do steps (7) and (8) for right and left rotors.
(7) Support front end plate (6) 4 in. (102 mm) off bench
with blocks.
NOTE
Gap between splines on rotor shaft must face
upward and align to one another.
(8) Tilt right hand rotor (1) and install into right hand side
of front end plate (6).
(9) Repeat step (8) for left-hand rotor (1).
(10) Apply light coat of grease (Item 1, Appendix E) to
front end plate side of blower housing (7).
(11) Align top of blower housing (7) with top edge of
front end plate (6).
(12)
Align dowel pins (8) and install in front end plate
(6).
(13)
Install and tighten two screws (9) to 10 Ib-ft
(14 N•m).
(14) Apply lubricating oil (item 10, Appendix E) to oil seal
rings (3).
(15) Apply light coat of grease (Item 1, Appendix E) to rear
end plate surfaces of blower housing (7).
5-132
|
