|
| |
TM 5-4210-233-14&P-1
4-24. PRIMER CABLE
This task covers:
a.
Removal
c.
Follow-on Maintenance
b.
Installation
TOOLS REQUIRED
EQUIPMENT CONDITION
Tool Kit, General Mechanics, Automotive
Main Engine Shutdown (see para. 2-12.)
(Appendix B. Section III, Item 1)
APU Shutdown (see para. 2-16.)
Batteries Disconnected (see para. 4-114.)
Gauge Panel Removed (see para. 4-18.)
Curbside Panel Removed (see para. 4-26.)
a.
Removal.
(1) Unscrew handle (1 ) from cable (5).
(2) Remove nut (2), nut (3), and washer (4) from
cable (5).
(3) At primer pump, loosen screw (6) and washer (7)
and remove cable clamp (8) from cable (5).
(4) Remove two nuts (9), two washers (10) and two
screws (11 ).
(5) Remove cable clamps (12) from cable (5).
(6) Remove cable (5).
b.
Installation.
(1) Install cable (5) through street side operators
panel.
(2) Install washer (4), nut (3), nut (2) and handle (1).
Tighten nut (2) against handle (1).
(3) Install cable clamps (12) on cable (5) and install
two screws (11), two washers (10) and two nuts
(9).
(4) Install cable clamp (8) on cable (5).
(5) At pump panel, push PRIMER handle (1 ) in as
far as possible
(6) Install washer (7) and screw (6).
(7) Check operation of primer valve. Adjust position
of cable clamp (8) as necessary.
c.
Follow-on Maintenance.
(1) Install gauge panel (see para. 4-18).
(2) Install curside panel (see para. 4-26).
(3) Connect batteries (see para. 4-114).
4-181
|
