|
| |
ENGINE DIVISION SERVICE MANUAL
TM 5-4210-230-14&P-1
ENGINE
2.
Position another adapter SE-1897-7 in the third
bearing with the flange toward the rear of the block,
Figure 78.
3.
Install the bar through the adapters and lock the third
bearing adapter on the bar with a "C" washer
SE1897-2.
4.
Using the second bearing adapter as a pilot, pull the
third bearing with the slide hammer, Figure 78.
NOTE:
Always hold the adapter firmly against the
bearing being removed or installed to
avoid damage.
Fig. 78 Removing Third Bearing
1.
Slide hammer
4.
Bar
2.
Second adapter
5.
C-washer
3.
Third adapter
6.
Bearing
Fig. 79 Installing Third Bearing
1
Slide hammer
4
Bar
2.
Second adapter
5.
C-washer
3.
Third adapter
6.
Align oil holes
7.
Bearing
5.
Position the new bearing on the third adapter and
install adapter and bar with a "C" washer in front of
the adapter, Figure 79. Align the oil hole and push in
the third bearing.
6.
Position the front adapter SE-1897-7 in the front
bearing with the flange toward the front of the block,
Figure 80.
7.
With the second adapter still in position, install the
bar through the adapters and lock the second
adapter on the bar with "C" washer, Figure 80.
Fig. 80 Removing Second Bearing
1
Slide hammer
4.
Front adapter
2.
Second adapter
5.
Bearing
3
Bar
6.
C-washer
8.
Using the front adapter as a pilot, pull the second
bearing with a slide hammer, Figure 80.
NOTE:
Always hold the adapter firmly against the
bearing being removed or installed to
avoid damage.
9.
Position the new bearing on the second adapter and
with the adapter flange toward the front of the block,
install the bar through the front and second adapter.
Then install "C" washer in front of the second
adaptor. Align the oil hole and push in second
bearing, Figure 81.
CGES-210 Page 29
PRINTED IN UNITED STATES OF AMERICA
|
