|
| |
ENGINE DIVISION SERVICE MANUAL
TM 5-4210-230-14&P-1
ENGINE
Fig. 50 Flywheel Removal
1. Flywheel
2. Mounting bolts
Fig. 51 Removal of Engine Front Cover
1. Front Cover
3. Gasket
2. Dowel pins
58.
Press front cover oil seal from front cover using a 3-
1/4" O.D. flat disc from the SE-1905 Set, Figure 52.
NOTE: Where it is the desire to replace the
engine front cover oil seal while the engine is in
the chassis, it will be necessary to remove the
hood, radiator shell, radiator and crankshaft
pulley. Then using puller, SE-2091, remove seal
as shown in Figure 53. To reinstall the seal,
follow note under Step 15 outlined under "Engine
Assembly."
Fig. 52 Front Cover Oil Seal Removal with Cover Removed
Using SE-1905 Handle and 3-1/4" O.D. Disc
1. Front cover
3. Handle
2. Press ram
4. Disc
Fig. 53 Front Cover Oil Seal Removal with Cover Installed.
Using SE-2091 Puller
1. Front cover
3. Puller
2. Seal
59.
Remove retainer plate bolts and remove retainer plate
with rear oil seal and gasket, Figure 54.
60.
Remove bolts from flywheel housing and remove
flywheel housing, Figure 55.
NOTE: Use extreme care when removing
flywheel housing to prevent damaging the dowel
pins.
CGES-210 Page 21
PRINTED IN UNITED STATES OF AMERICA
|
