|
| |
ENGINE DIVISION SERVICE MANUAL
TM 5-4210-230-14&P-1
ENGINE
Fig. 42 Rocker Arm Removal
1. Rocker arms
3. Bolts
2. Push rods
4. Pivots
45.
Remove push rods from engine.
46.
Repeat Steps 44 and 45 on opposite cylinder head.
47.
Lift out all hydraulic valve lifters or tappets from the
crankcase assem-, bly, Figure 43. This can be
accomplished by rotating the camshaft so the tappets
are resting on the high side of the camshaft lobes.
Keep the tappets in order in storage box, SE-1894, to
assure cleanliness and reinstallation in their original
bores.
Fig. 43 Hydraulic Tappet Removal
1. Hydraulic tappet
48.
Remove cylinder head bolts and lift cylinder heads off
the two locating dowel sleeves, Figure 44. Remove the
cylinder head gasket.
CAUTION: Use extreme care when handling to prevent
damage to gasket surfaces. Never pry between the
cylinder heads and the block as their have a finished
surface and must not be damaged.
Fig. 44 Dowel Sleeves in Block for Cylinder Head
1. Dowel sleeves
49.
Repeat Step 48 and remove opposite cylinder head.
50.
Remove bolts and lockwashers securing water pump to
engine, Figure 45. Remove water pump and gasket.
Fig. 45 Water Pump Removal
1. Water pump
2. Mounting bolts
CGES-210 Page 19
PRINTED IN UNITED STATES OF AMERICA
|
