|
| |
TM 5-4210-230-14&P-1
TRUCK SERVICE MANUAL
Fig. 18 Axle Shaft Lock Ring
5.
Place universal joint on top of axle shaft index end of
axle shaft in splined inner race. Tap end of universal
joint shaft with a soft faced hammer to collapse lock
ring, securing assembly. See Fig. 19.
Fig. 19 Assembling Axle Shaft and Universal Joint
6.
Pack universal joint bell with lubricant.
Trunnion Housing Assembly
1.
Using original shim pack install upper trunnion cap.
Torque retaining nuts to 81 to 95 Newton Meters (60 to
70 ft.lbs). On trunnion housings equipped with steering
arms,
install
tapered
dowels
before
installing
lockwashers and retaining nuts. Torque retaining nuts
to 81 to 95 Newton Meters (60 to 70 ft.lbs.). Refer to
Fig. 8.
2.
Lubricate
trunnion
bearings
thoroughly.
Place
a
trunnion bearing on upper trunnion bearing cup of axle
housing end. Lower trunnion housing into place on axle
housing end indexing upper trunnion pin with upper
trunnion bearing.
3.
Place lower trunnion bearing in bottom of trunnion
housing and align with lower bearing cup. Using
original shim pack install lower trunnion cap. Torque
retaining nuts to 81 to 95 Newton Meters (60 to 70
ft.lbs.).
Fig. 20 Checking Bearing Adjustment
CTS-2658S Page 18
PRINTED IN UNITED STATES OF AMERICA
|
