|
| |
TM5-4210-229-14&P
6-16.
REAR RETAINER OIL SEAL REPLACEMENT (Continued).
d.
Attach the centering plate (3) to the crank shaft
flange (4) using the four allen head screws. Do
not tighten the screws at this time.
NOTE
Only four bolt holes in the crankshaft will line
up with the holes in the centering plate.
Never remove the oil seal from the sleeve
during assembly.
e.
Position the wear sleeve (5) with oil seal (6) on
the centering plate (3) and crankshaft. Tighten
the four allen head screws.
f.
Coat the I.D. of wear sleeve (5) and O.D. of oil
seal (6) with a thin film of RTV sealant (Appendix
D, Item 45). Do not get any sealant on the seal
lip or O.D. of the wear sleeve (5).
g.
Position the wear sleeve and oil seal installing
tool (7) on the centering plate (3) then tighten
thrust washer (8). This will center the wear sleeve
(5) and oil seal (6) on the crankshaft.
(h) Install flywheel (paragraph 6-13).
6-94
|
