|
| |
TM5-4210-229-14&P
6.15
TRANSMISSION REPAIR (Continued)
(g) Install the selected snapring and remove the
compressor from the transmission.
(2) Second clutch clearance.
(
a)
Invert the transmission housing, output end
upward.
(b)
Using second clutch gauge, check the second
clutch plate clearance. Insert the gauge
between
the
backplate
(332)
and
the
transmission
housing.
The
pre-scribed
clearance is 0.049-0.111 inch (1.24-2.82 mm).
When this clearance is achieved, the first step
of the gauge will fit between the backplate and
the transmission housing; the second step will
not.
(c)
If the clearance is not satisfactory, measure the
total plate thickness, and replace all plates
necessary to satisfy the prescribed clearance.
If required the backplate (332) may be replaced
by a thicker or thinner plate.
(3) Rear cover installation.
(a)
Place the rear cover gasket (41) on the
transmission housing, aligning the holes in the
gasket with those in the housing.
(b)
Install the rear cover assembly (39), onto the
transmission housing (40).
(c)
Install fourteen ½ -13x1-1/2 inch bolts and
washers to retain the rear cover assembly (39).
Torque two bolts that are 180 degrees apart to
33 ft-lb (45 N.m). Move approximately 90
degrees around the bolt circle and re-peat the
operation. Torque the remaining bolts at 180
degree increments to33 ft-lb (45 N.m). Repeat
the entire process and torque the fourteen bolts
to 67-80 ft-lb (91-108 N.m).
(a)
6-85
|
