INSTALLATION - TM-5-4210-224-14-P0445

TM 5-4210-224-14&P

4-248. HUB AND DRUM ASSEMBLY REPLACEMENT (Continued).

c. Use wheel bearing nut wrench to remove adjusting

nut (4) from housing tube. Remove thrust washer (5)

from housing tube.

d. Pull hub and drum assembly straight off axle

housing.

e. Remove and discard oil seal.

INSTALLATION

a. Using a high melting point EP bearing lubricant

(Appendix D, Item 25) liberally pack bearings

and apply a light coat on the inside diameter of

the hub bearing contact surface and outside

g. Install wheel assembly (paragraph 4-203).

diameter of axle housing tube.

h. Lower vehicle.

b. Ensure inner bearing oil seal (6), axle housing

oil deflector, and inner bearing race (7) and oil

seal are positioned properly.

c. Install hub and drum assembly on axle housing,

while exercising care to ensure oil seal is not

damaged or other internal components are not

dislocated.

d. Install thrust washer (5) so that tang on inside

diameter of washer is in keyway on axle

housing.

e. Install adjusting nut (4) and complete the

installation by adjusting bearing following

f. Install rear axle shaft (paragraph 4-247).

4-350