Section V. WATER TANK - TM-5-4210-213-350060

Bolt

Washer

Nipple

Spring

Bearing

Insuliner

Brush arm

Brush cap

Armature

Brush

Key

End bell

Washer

Brush holder

Shield

Insulator

Nut

Shield

Stator

Set screw

Plate

Capacitator

Screw

Figure 3-15A-Continued.

Section V. WATER TANK

3-20. General

d. Cleaning

Clean all parts in an approved

The water tank is made from fabricated welded stainless

cleaning solvent and dry thoroughly.

steel panels, and has a capacity of 400 gallons. The

e. Inspection and Repair.

tank is fully insulated and equipped with four lifting eyes

(1) Inspect all parts for wear, defects and

for removal.

damage.

An over-flow pipe is mounted on the left front side of the

(2) Replace or repair worn, defective and

tank. The tank is mounted directly on the carrier

damaged parts as necessary.

chassis.

(3) For welding purpoes to repair leaks, the

3-21. Water Tank

water tank is fabricated from 12 gage ASTMA167 Grade

a. General. Refer to paragraph 3-20.

3 steel.

b. Removal.

f. Reassembly. Refer to figure 3-17 and reassemble

(1) Drain the watertank (TM 5-4210213-12).

the water tank in reverse order.

(2) Remove the foam tank and ladder support

g. Installation.

assemblies (TM 5-4210-213-12).

(1) Refer to figure 3-16 and install the water

(3) Refer to figure 3-16 and remove the water

tank and lines on special purpose body.

tank from the special purpose body.

(2) Install the foam tank and ladder support

c. Disassembly.

Refer to figure 3-17 and

assemblies (TM 5-4210-213-12).

disassemble the water tank.

(3) Fill the water tank (TM 5-4210-21312).

3-35