 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 22
Key
35
Cotter pin
23
Screw, cap, 7/16-20 x 2 in. (6)
36
Nut, special
24
Pump head
37
Gear
25
Gasket
38
Key
26
Screw, special
39
Bearing
27
Nut, 5/16-18 (2)
28
Housing
48
Screw, cap, 7/16-20 x 1 1/4 in. (4)
29
Gasket
49
Washer, flat, 7/16 in. (4)
30
Gland
50
Plate
31
Sleeve
51
Gasket
32
Packing (as)
52
Strainer
33
Shaft
53
Stud, 7/16-20 x 6 1/2 in. (9)
34
Bearing
54
Body
Figure 3-1 4-Continued.
Section IV. HOSE REEL ASSEMBLY
3-17. General
e. Inspection and Repair. Inspect all parts for
Two electric motor driven hose reels are mounted in the
wear, defects, and damage. Replace or repair worn,
reel compartments behind the cab. An electric rewind
defective, or damaged parts as necessary.
button is installed on each pump control panel to permit
f. Reassembly
.
Refer to figure 3-15 and
automatic rewinding of the hose on each reel. A reel
reassemble the hose reel assembly in the reverse order.
handcrank provides a means of rewinding the hose, in
g. Installations Install the hose reel assembly (TM
.
the event of failure in the electrical system. Each reel is
5-4210-213-12).
chain driven by a 1/t horsepower electric motor, or
3-19. Hose Reel Motor
handcrank by a pinion gear working on the reel ring
a. General. The hose reel motor supplies power to
gear.
the hose reel.
3-18. Hose Reel Assembly
b. Removal. Refer to TM 5-4210-213-12.
b. Removal. Remove the hose reel assembly (TM
d. Cleaning. Clean all parts with an approved
5-4210-213-12).
cleaning solvent, and dry thoroughly.
c. Disassembly.
Refer to figure 3-15 and
e. Inspection and Repa.r Inspect all parts for
i
disassemble the hose reel assembly.
damaged or defective condition.
d. Cleaning
.
Clean all parts in an approved
f. Reassembly. Replace or repair damaged or
cleaning solvent and dry thoroughly.
defective parts as necessary. Refer to figure 3-15A.
g. Installation. Refer to TM 5-4210-213-12.
.
3-31
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals