Hose Bed Assemblies

two parts. The two hose bed assemblies, which are

(3) Replace or repair damaged or defective

constructed of wood slats, lay on top of the water tank.

parts as necessary.

The three ladder support assemblies are attached to the

c. Installation. Refer to figure 22, and install the

sides of and extend above the right and left

fire extinguisher bracket on the rear step.

compartment assemblies.

60. Tool Box Door

56. Hose Bed Assemblies

a. Removal. Refer to figure 22, and remove the

tool box door from the rear step.

hose bed assemblies from the water tank.

b. Cleaning, Inspection, and Repair.

(1) Clean all parts with an approved cleaning

(1) Clean all parts in an approved cleaning

solvent, and dry thoroughly.

12) Inspect all parts for damaged or defective

(2) Inspect all parts for damaged or defective

condition.

(3) Replace or repair damaged or defective

parts as necessary.

c. Installation. Refer to figure 22, and install the

tool box door on the rear step.

hose bed assemblies on the water tank.

61. Rear Step

57. Hose Bed Partition

a. Removal.

a. Removal. Refer to figure 22, and remove the

(1) Remove the fire extinguisher bracket (para.

hose bed partition from the water tank.

59).

b. Cleaning, Inspection, and Repair.

(2) Remove the side handrails and panels (para.

(1) Clean all parts with an approved cleaning

58).

solvent, and dry thoroughly.

(3) Refer to figure 22, and remove the rear step

(2) Inspect all parts for damaged or defective

from the special purpose body.

condition.

b. Cleaning, Inspection, and Repair.

(3) Replace or repair damaged or defective

(1) Clean all parts with an approved cleaning

parts as necessary.

solvent, and dry thoroughly.

c. Installation. Refer to figure 22, and install the

(2) Inspect all parts for damaged or defective

hose bed partition on the water tank.

condition.

(3) Replace or repair damaged or defective

58. Handrails and Brackets

parts as necessary.

a. Removal. Refer to figure 22, and remove the

c. Installation.

handrails and brackets from the special purpose body.

(1) Refer to figure 22, and install the rear step

b. Cleaning, Inspection, and Repair.

on the special purpose body.

(1) Clean all parts with an approved cleaning

(2) Install the side handrails and panels (para.

solvent, and dry thoroughly.

58).

(2) Inspect all parts for damaged or defective

(3) Install the fire extinguisher bracket (para.

condition.

59)

(3) Replace or repair damaged or defective

parts as necessary.

62. Shovel Brackets

c. Installation. Refer to figure 22, and install the

a. Removal. Refer to figure 22, and remove the

handrails and brackets on the special purpose body.

shovel brackets from the apron.

b. Cleaning, Inspection, and Repair.

59. Fire Extinguisher Bracket

(1) Clean all parts with an approved cleaning

a. Removal. Refer to figure 22, and remove the

solvent, and dry thoroughly.

fire extinguisher bracket from the rear step.

(2) Inspect all parts for damaged or defective

b. Cleaning, Inspection, and Repair.

condition.

(1) Clean all parts with an approved cleaning

(3) Replace or repair damaged or defective

solvent, and dry thoroughly.

parts as necessary.

(2) Inspect all parts for damaged or defective

condition.

TAGO 6839A