|
| |
TRUCK SERVICE MANUAL
TM 5-4210-230-14&P-1
BODIES AND CABS
Fig. 45. Side Panel to Roof Outer and Inner Panel Spot
Welds (Outer Roof Panel Not Shown)
9.
Drill out three spot welds and separate side panel
from roof outer and inner panels (Fig. 45).
10. Drill out fourteen spot welds along top of door
opening and separate side panel from roof inner
panel (Fig. 46).
Fig. 46. Side Panel to Roof Inner Panel Spot Welds
11. Drill out fifteen spot welds along bottom of door
opening and separate side panel from sill side inner
panel (Fig. 47). Note that on 80" wide cabs there are
additional spot welds to be removed at lower front
corner of door opening.
12. Drill out three or four additional welds along top edge
of windshield opening as required to separate roof
panels and raise roof panel sufficiently to permit
removal of side panel from cab.
IMPORTANT
Be careful while removing side panel so as to
avoid damage to roof panel.
Fig. 47. Side Panel To Sill Side Inner Panel Spot Welds
CTS-2714R Page 26
PRINTED IN UNITED STATES OF AMERICA
|
