TRUCK SERVICE MANUAL
BODIES AND CABS
Fig. 40. Side Panel to Back Panel Spot Welds (Right Corner
90" Wide Cab Shown)
Drill out spot welds along seam between back panel
and side panel and separate rear of side panel from
back panel (Fig. 40). Drill at outer seam if for 90"
Drill out spot welds along seam at bottom of cab and
separate rocker panel from sill side inner panel (Fig.
Drill out spot welds at seam between dash filler panel
and dash panel. Separate filler panel from dash
panel (Fig. 42).
Drill out five spot welds and separate windshield side
outer panel from cowl top inner panel (Fig. 43).
Drill out six spot welds and separate windshield side
outer panel from cowl rear panel and bracket (Fig.
Fig. 41. Rocker Panel to Sill-Side Inner Panel Spot Welds
Fig. 42. Filler Panel to Dash Panel Spot Welds
Fig. 43. Windshield Outer Panel to Cowl Inner Panel Spot
Welds (Rt. Side Shown)
Fig. 44. Windshield Side Outer Panel to Cowl Rear Panel and
Bracket Spot Welds
CTS-2714R Page 25
PRINTED IN UNITED STATES OF AMERICA