 |
|||
|
|
|||
|
Page Title:
Table 3-1. Test Set Controls and Indicators |
|
||
| ||||||||||
|
|
 TM 9-4931-363-14&P
Nomenclature
Function
Ref des
J4 HELMET connector
J4
Connects signals and other voltages between test set
and helmet sight assembly
J10 BUFFER AMPL
J10
Connection for EIA buffer amplifier
connector
J5 LINKAGE connector
J5
Connects signal voltages between test set and linkage
assemblies
J15 EXT CABLE
J15
Connection for extension cable W1
connector
J3 POWER connector
J3
Connects 115 volts, 60-Hz or 115 volts, 400-Hz power
from primary power source to test set
J2 TEST connector
J2
Connects signals and other voltages between test set
and units under test
J1 INPUT connector
J1
Connects signals and other voltages between test set
and units under test
PHASE 0 indicator
DS20
Lights to indicate ac voltage of selected test is in phase
PHASE 180 indicator
DS19
Lights to indicate ac voltage of selected testis out of
phase
Ml
Displays multitude of selected voltages during assembly
Digital multimeter
and subassembly tests
J16, J17
Used as external connection when using multimeter for
METER JACKS
external use. METER SELECT switch must be set to
J16, J17
OFF for this operation
Lights when failure occurs in pilot's linkage assembly
PILOT LINKAGE
DS16
during HSS test
indicator
Lights when failure occurs in gunner's linkage assembly
DS15
GUNNER LINKAGE
during HSS test
indicator
DS14
Lights upon successful completion of HSS test
GO indicator
DS17
Lights when failure occurs in EIA during HSS test
EIA indicator
DS7
Lights to indicate proper operation of power fail monitor
POWER SUPPLY BIT
circuit during system, EIA, and power supply card tests
indicator
J6
Connection for EIA power supply card
J6 POWER CARD
connector
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals