|
| |
TM 9-254
4-23.
Removing Nicks and Burrs - Continued
(2)
To remove burrs from an edge which is rounded, use a round fine-cut file in a sawing action along the
edge as shown in figure 4-50.
Figure 4-50. Using a Round File
(3)
If the motion in step (2) is not possible, use a careful circular motion along the edge of material.
(4)
To remove burrs from machined surfaces, use a honing stone and pass across burr in a back and forth
motion as shown in figure 4-51.
Figure 4-51. Removing Burrs From a Flat Surface
4-55
|
