DISASSEMBLY - TM-55-1925-292-14-P0315

TM 55-1925-292-14&P

0040 00

5. Remove the spring guide (figure 1, item 10), spring (figure 1, item 11), and the poppet (figure 1, item 12) from

the relief valve faceplate (figure 1, item 9).

6. Remove the plug cap (figure 1, item 13) and the gasket (figure 1, item 14) from the relief valve faceplate

(figure 1, item 9). Discard the gasket.

7. Remove the pipe plug (figure 1, item 15) from the relief valve faceplate (figure 1, item 9).

8. Remove the 16 bolts (figure 1, item 16) from the relief valve faceplate (figure 1, item 9) and remove the relief

valve faceplate and gasket (figure 1, item 17) from the case (figure 1, item 18). Discard the gasket.

9. Remove the relief valve faceplate bushings (figure 1, item 19) from the relief valve faceplate (figure 1, item 9).

10. Remove the six bolts (figure 1, item 20) from the bearing cartridge (figure 1, item 21).

11. Remove the bearing cartridge (figure 1, item 21) from the back plate assembly (figure 1, item 22).

12. Remove the gasket (figure 1, item 23) from the back plate assembly (figure 1, item 22). Discard the gasket.

13. Remove and discard the retaining ring (figure 1, item 24) from the bearing cartridge (figure 1, item 21).

14. Loosen the setscrew (figure 1, item 25) in the bearing cartridge (figure 1, item 21) that secures the bearing

(figure 1, item 26).

15. Remove the bearing (figure 1, item 26) from the bearing cartridge (figure 1, item 21).

16. Remove the stationary seat (figure 1, item 27) of the mechanical seal (figure 1, item 28) from the bearing

cartridge (figure 1, item 21).

17. Remove the rotating element (figure 1, item 29) of the mechanical seal (figure 1, item 28) from the drive shaft

(figure 1, item 30).

18. Remove the lubrication fitting (figure 1, item 31) from the bearing cartridge (figure 1, item 21).

19. Remove the case (figure 1, item 18) from the back plate assembly (figure 1, item 22).

20. Remove the gasket (figure 1, item 32) from the back plate assembly (figure 1, item 22). Discard the gasket.

21. Remove the drive shaft (figure 1, item 30), drive gear (figure 1, item 33), and idler gear and shaft (figure 1,

item 34) from the case (figure 1, item 18).

22. Remove the key (figure 1, item 35) from the drive gear (figure 1, item 33) and the drive shaft (figure 1, item 30).

23. Remove the drive gear (figure 1, item 33) from the drive shaft (figure 1, item 30).

24. Remove the flange bushings (figure 1, items 36) from the back plate assembly (figure 1, item 22).

0040 00-3