DRAFT
TM 5-4210-249-13&P-2
0195
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
TFFT00904A
NOTE
Use the suggested tension setting for initial tensioning. Run water pump engine under
load for 15 minutes, shut down and readjust belt tension.
Suggested belt tensions have a range of +/- 11 lb-ft (15 Nm).
4.
Start pump engine and run under load for 15 minutes.
5.
Shut down engine and readjust fuel pump drive belt (6) tension to 67 lb-ft (300 Nm), as indicated by V-belt
tension gauge.
END OF TASK
FOLLOW-ON MAINTENANCE
1.
Install water pump engine alternator belt (WP 0224)
2.
Install water pump engine heat exchanger (WP 0240)
3.
Install pump house panels J and U (WP 0540)
END OF TASK
END OF WORK PACKAGE
0195-2