DRAFT
TM 5-4210-249-13&P-2
0187
2.
Position male fitting on female fitting. Tighten only finger-tight.
3.
Scribe alignment mark on both fittings.
CAUTION
It may be necessary to tighten fitting slightly more or less than 2-1/2 turns to match
position noted prior to removal. Do not loosen fitting to arrive at proper position or
a leak may occur.
Overtightening may cause pipe fitting to deform and damage to the joining fitting,
flange, or component.
4.
Tighten male fitting 2-1/2 (3 maximum) full turns past hand-tight position.
PREPARATION FOR SHIPMENT OR STORAGE
Proper preservation of a vehicle and its individual parts for storage or shipment is vital to the life of the equipment.
a.
Perform pump and blow-out procedures (WP 0044).
b.
Perform preparation for storage or shipment (WP 0043).
c.
For general preservation data as well as preservation procedures for vehicle specific parts, refer to Equipment
Preservation Data Sheets (EPDS).
d.
Refer to TM 9-2320-325-14&P for preparation for shipment or storage information.
e.
Refer to TM 43-0213 Corrosion Prevention and Control (CPC) for Tactical Vehicles.
f.
Refer to TB 9-2300-281-15 for overseas shipment instructions.
g.
Refer to TB 9-2300-281-15 for Basic Issue Items (BII) packing instructions.
END OF WORK PACKAGE
0187-11/(12 blank)
