DRAFT
TM 5-4210-249-13&P-2
0187
Torquing.
c.
(1)
Tighten bolts, screws, washers, hoses, and fittings as required in WP 0609 or in each
maintenance task.
(2)
Apply a small amount of colored sealing compound to connection to mark torque point.
Identification Tags.
d.
Put hoses, tubes, lines, and electrical wiring in place by matching identification tags and markings on
equipment.
Hoses, Air Lines, and Wiring.
e.
After installing hoses, air lines, and wiring, ensure that they do not contact moving parts or component edges.
Secure in place, out of way, with cable ties and cushion clips.
f.
Hose and Fitting Tightening Procedures.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
TFFT04155
NOTE
Tighten hoses and fittings as required in WP 0609 or in each maintenance task. If a
torque wrench and crowsfoot are not available or cannot be used, use the following
procedure.
1.
Install hose (1) on fitting (2).
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
0187-8