DRAFT
TM 5-4210-249-13&P-2
0174
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
TFFT04468
NOTE
If wire 2740 cannot be identified at door switch, measure continuity across switch from
terminal wire 1609 (gray) to both black wire terminals. Continuity should be measured
between all terminals when switch is closed (door switch is not pressed).
Step 16.
Turn Service Drive Lights Off (TM 9-2320-347-10). Turn battery disconnect switch to
OFF position (WP 0007). Remove rear stowage compartment R-1 door switch
(WP 0385), do not disconnect wires. Check for continuity between door switch terminal
wire 1471 (black) and a known good ground when switch is closed (door switch is not
pressed).
If there is continuity, go to Step 19.
Step 17.
Check for continuity across door switch between terminal wire 1471 (black) and
terminal wire 2740 (black).
If there is no continuity, replace door switch (WP 0385).
Step 18.
With a test lead set, check for continuity across main wire harness wire 2740 (black)
from passenger side body wire harness rear body wire harness connector, terminal E to
a known good ground.
a.
If there is continuity, repair wire 2740 in rear body wire harness if
repairable (TM 9-2320-325-14&P), or replace rear body wire harness
(WP 0461).
b.
If there is no continuity, repair wire 2740 in main wire harness if
repairable (TM 9-2320-325-14&P), or replace main wire harness
(WP 0455).
0174-13
